CG 500-35 Two - Component Epoxy CARTRIDGE 50ml

This CG500 is in a CARTRIDGE and WILL need a 2part Epoxy Applicator Gun.
Component A - Epoxy Resin. Component B - Hardener.
9030 CG 500 (A+B). Comes with 2 Nozzles.
50ml.

CG 500-35 Two-Component Epoxy Resin Glue. This is a two-part glue is especially well-suited for use in jewelry and accessories, electronics, and interior markets. It adheres to materials such as metals, rubbers, synthetics, and glass. It’s highly resistant to humidity, chlorine, salt, mechanical stress, and UV light. To use, mix equal parts together in a 1:1 ratio for one minute.

In line with "leading crystal manufacturer's" socially and environmentally responsible practices, the Two-Component Epoxy Resin Glue uses only high-grade ingredients and is NOT considered Toxic, Explosive, Corrosive, Hazardous, or Dangerous for the Environment. Use with adequate ventilation.

General Information
"leading crystal manufacturer" CG 500 glue is a very flexible and extremely strong two-component Epoxy Resin adhesive, which has been specially developed for gluing "leading crystal manufacturer" Crystals. It has optimal adhesive characteristics for gluing with metal, glass, crystal, glue-able synthetic surfaces, rubber, wood, cork, and porcelain. In addition, the mirrored surface of the crystal is protected against mechanical stress by the gentle build-up of adhesion, the optimized load transmission, and maximum elasticity. The following products are suitable for gluing: Round Stones, Flat Backs No Hotfix, Fancy Stones, Crystal Pearls, Self-adhesive Elements, Crystal Fabric, Crystal Rocks & Crystal Fine Rocks, Crystaltex & Crystaltex Chaton, Plastic Trimmings, Flat Back & Chaton Bandings, Crystal Mesh, Knobs, Handles & Co.

Useful information:
1. Use a suitable dispenser to apply exactly the right amount of glue. Dispensers with a vacuum connection prevent the glue from dripping and reduce the amount of cleaning needed.
2. Be sure to use the exact recommended dosage and to carefully remove any excess glue using e.g. acetone or isopropyl alcohol.
3. It is recommended to complete the plating before gluing the crystals.
4. Follow the glue manufacturer’s mixing instructions.
5. If cleaning agents have affected the glue and/or the protective coating, use less solvent or a different type of solvent.
6. Re-work the original model to improve the cavity shape.
7. Make sure the glue has hardened before e.g. transporting the jewelry.
8. These adhesives are heat-resistant and dry better at high temperatures.
9. Sole responsibility for any application, product use, and technical process lie with the customer.

SDS SHEET